ESC 30A With Simonk Firmware
Approx. Rs 750 / Piece
This is 30A ESC for multirotor
This hardware, with the SimonK firmware, gives you the perfect solution for multirotor use.
Highest efficiency 100% N-FET design.
Highest accuracy with crystal oscillator (Temperature won't affect the PWM operating range like other cheap ESC's).
No low voltage cutoff, because any cutoff in a multirotor = crash.
No over temp cutoff, because any cutoff in a multirotor = crash.
Super high refresh rate, no buffering of the input signal, resulting in more than 490Hz response rate.
16KHz motor frequency, giving fastest response of the motor, and quietest operation as well (no 8KHz squeal).
Super simple, foolproof operation. Nothing to program other than the throttle rangeSpecification:-
- Continuous Current:30ABurst
- LIpo Cells:2-4
Electronic Speed Controller 30A - DYS
Approx. Rs 700 / Piece
This is a Multi-copter Brushless Motor Speed Controller with a running current of 30A. The power input uses extreme low output resistance greatly enhance the power stability, and has the protective effect on the battery.Separately voltage regulator IC for microprocessor. providing good anti-jamming capability. Using Simon K’s a dedicated multi-copter program tgy_debug, and the master chip with high stability crystal oscillator, making the motor control to more precise.
- Running current:30A(Output: Continuous 30A, Burst 40A up to 10 Secs.)
- Input Voltage: 2-5S LiPo
- BEC: 5V 2amp.
- Size: 46mm (L) * 26mm (W) * 11mm (H).
- Weight: 23g
- With SimonK updated firmware for Multicopter