Send SMS
Contact Us

RFID NFC Module & Card

RFID Reader - Serial Out

RFID Reader - Serial Out

Approx. Rs 450 / Piece

Description: This is a low frequency (125Khz) RFID Reader Serial Out with at range of 8-10cm. It is a compact units with built in antenna and can be directly connected to the PC using RS232 protocol.This product is a kind of play and plug device with a reading range of 8 to 10 cm and can be availed in the following specifications.

Specifications:

Additional Information:

Mcp2515 Can Bus Module

Mcp2515 Can Bus Module
  • Mcp2515 Can Bus Module
  • Mcp2515 Can Bus Module

MCP2515 Module adopts CAN controller MCP2515, and TJA1050 high-speed CAN transceiver. Onboard independent key. Microchip MCP2515 independent CAN protocol controller, support CAN V2.0B regulation. The connection between MCP2515 and MCU is through SPI.

Specifications:

RC522 Reader/ Writer Module

RC522 Reader/ Writer Module

Approx. Rs 200 / Piece


RC522 is a highly integrated read and write 13.56MHz contact-less communication card chip, for applications of a low-voltage, low-cost, small size of the non-contact card chip to read and write, smart meters and portable hand-held devices. The RC522 use of advanced modulation and demodulation concept completely integrated in all types of passive contact-less communication methods and protocols. 14443A compatible transponder signals. It can handle the ISO14443A frames and error detection. In addition, it support rapid CRYPTO1 encryption algorithm, terminology validation products. RC522 support series of high-speed non-contact communication, two-way data transmission rate up to 424kbit/s.

Specifications:

Libraries:

Examples:

RF Card 13.56mhz

RF Card 13.56mhz

Approx. Rs 40 / Piece


Description: This TK4100 card can be read by almost any RFID/NFC reader or NFC-enabled mobile devices.

Features:

RFID Clamshell Card/TAG 125kHz

RFID Clamshell Card/TAG 125kHz

Approx. Rs 40 / Piece

Description: This is a basic VLF RFID Clamshell Card/Tag used for presence sensing, Aceess Control etc. Works in the 125kHz RF range. These tags come with a unique 32-bit ID and are not re-programmable. Card is blank, smooth, and mildly flexible.

 

RFID Clamshell Card (125kHz) Features:



Additional Information:

RFID Key Fob 13.56MHz

RFID Key Fob 13.56MHz

Approx. Rs 40 / Piece

Product Description

13.56MHz RFID Smart IC Key Fobs Token Tag/ IC Tag Token Key Ring/ IC Cards.

Technical Specifications

RFID Module 125KHz RDM6300 - UART

RFID Module 125KHz RDM6300 - UART
  • RFID Module 125KHz RDM6300 - UART
  • RFID Module 125KHz RDM6300 - UART

Approx. Rs 250 / Piece

RDM6300 125KHz cardreader mini-module is designed for reading code from 125KHz card compatible read-only tags and read/write card . It can be applied in office/home security, personal identification, access control, anti-forgery, interactive toy and production control systems etc.

Features:

RFID Reader Module TTL

RFID Reader  Module TTL

Approx. Rs 425 / Piece


Description: This board uses the EM18 RFID Module. It can be used to read our RFID cards. Using the board with micro controllers to read a card's data is very simple and required just a serial connection. The board should be powered at 5V, and it requires a direct connection to the micro controller's Serial Rx pin. The card data is transmitted over the serial line when the card is brought near the module.

 

The board has an onboard power indication LED, a LED and Buzzer to indicate the presence of a RFID Card. All the IO pins are brought out to standard clearly labeled header pins, which simplify prototyping time and effort. An output pin (DET) also indicates the presence of a RFID card. The board can also be used to output data in Wiegand format. It can detect cards in the range of 8-10cm.


Additional Information:

RFID Reader EM18 Module

RFID Reader EM18 Module

Approx. Rs 275 / Piece


Description: This RFID Reader Module 125Khz is eary to use. It is Low Cost. It gives Serial and Wiegand26 Output.

Specifications:


Additional Information:

RFID Tag Keyfob (125kHz)

RFID Tag Keyfob (125kHz)

Approx. Rs 40 / Piece

Description: This is a basic RFID Tag Keyfob used for presence sensing , Access control etc. Works in the 125kHz RF range. These tags come with a unique 32-bit ID and are not re-programmable. Tag is blank, smooth, and mildly flexible.

RFID Tag Keychain (125kHz) Features:


Additional Information:

USB RFID Reader

USB RFID Reader

Approx. Rs 500 / Piece

Description: This is a plug and play RFID Reader USB. It can be used to read our 125kHz based RFID cards. Just connect the reader to the USB port and it creates a new COM Port on the computer. When a RFID card is brought near the Reader, the card's data is output using in ASCII through a simple USART interface. Since most programming languages allow access to COM ports, it is simple to write custom software programs to read RFID cards and process them as required. This board can also be used with microcontrollers to read card data. This reader is perfect for developing RFID based products and projects.

The reader has an onboard power indication LED, a LED and Buzzer to indicate the presence of a RFID Card. The reader can also be used to output data in Wiegand format. It can detect cards in the range of 4 - 7cm.

X
Provide Us More Details
Is this Requirement:

One Time Regular

How soon do you want this:

Immediate After 1 month

Purpose of Requirement:

Reselling End Use Raw Material

X

Looking for RFID NFC Module & Card ?

    country-ico

    We will contact you soon !

    Dileep Jain

    (CEO)

    Rajguru Electronics (I) Private Limited

    Lamington Road, Mumbai, Maharashtra, India

    More Categories

    View All Categories »
    Send SMS
    Contact Us